Sawmill Alignment
Blade Guide Vertical Tilt Adjustment
Sawmill Alignment HDSdoc041620 5-23
5
See Figure 5-24.
8. Move the carriage forward so the back end of the tool is over the bed rail.
9. Use the set screws shown to adjust the blade guide tilt until the measurement from the bed rail to the
tool equals the other two measurements taken.
10. Move the tool close to the other blade guide and repeat the previous steps.
NOTE: If major adjustments to blade guide tilt were made, measure the distance between the blade
and the bed rails again to ensure the correct 4.0 mm blade guide deflection. Adjust if necessary.
FIG. 5-24
Loosen jam nuts and turn screws
to tilt roller up or down
Loosen jam nuts and turn screws
to tilt roller up or down
To Next Page
Loading...
