Setup & Operation
Hydraulic Control Operation
2
2-16 15doc041620 Setup & Operation
CAUTION! Be careful when manually lowering the log loader. Do not
drop the loader onto the ground or perform any action which might
break the velocity fuse valves on the loader cylinders. These valves
control hydraulic flow and are necessary to prevent the loading arm
from collapsing during use.
8. Lower the loader lever to lower the loading arm as far as it will go. Logs must be rolled onto the
loading arm one at a time for loading onto the bed of the sawmill.
9. The front and rear toe boards should be below the bed level. Once a tapered log has been loaded,
the front or rear end of the log may be lifted to parallel the heart of the log to the path of the blade.
The front toe board is raised by lifting the front toe board lever up. The rear toe board is raised by
lifting the rear toe board lever up. Once a flat has been made and the log is ready to be turned,
push the appropriate toe board lever down to lower either toe board until it falls below the level of
the bed.
To Next Page
Loading...
