Setup & Operation
Blade Drive Operation
2
2-24 15doc041620 Setup & Operation
3. Start the motor as instructed in the motor manual.
See Figure 2-14. To engage the blade, perform the following steps:
- Turn the main switch on the electric box to the ON position,
- Press AND HOLD the green safety button on the control box.
NOTE: Keep the safety button pressed all the time the blade is driven. If the safety button is
released, the motor stops and it needs to be restarted.
- Press the START button on the control box to start the motor.
CAUTION! If at any time you need to immediately stop the blade
motor, press the emergency stop button located on the electric box.
FIG. 2-1
Debarker
Switch (Option)
Motor Start Button
Up/Down
Switch
Emergency Stop
Power Feed
Switch
Main Switch
Feed Rate
Adjustment
Debarker
In/Out
Blade Guide In/Out
(Option)
To Next Page
Loading...
