Sawmill Alignment
Blade Installation And Alignment
5
5-4 HDSdoc041620 Sawmill Alignment
Be sure to tighten all nuts against the mounting plates when the adjustment is complete.
The vertical angle of the drive side wheel is factory-set and should not need to be adjusted.
If adjustment is needed, use the vertical adjustment bolt. To tilt the wheel upward, loosen the jam nut
and turn the vertical adjustment bolt clockwise. To tilt the wheel downward, loosen the jam nut and
turn the vertical adjustment bolt counterclockwise. Be sure to tighten the jam nut.
FIG. 5-3
Vertical Adjustment
Bolt
Horizontal Adjustment
Bolt
To Next Page
Loading...
