9.3 Fuel Tank/Seat Cushion
9.3.1 Removal
Remove left and right protecting plates.
Insert ignition key into the seat lock. Rotate
clockwise the key and unlock it.
Pull downward and take out the helmet hook.
Release the pawl from frame and remove seat
cushion (1）
Remove connector from lead wire of oil level sensor.
Fuel switch shall be set at “OFF” position.
Disconnect fuel hose and carbon canister connecting hose.
Remove bolt, washer, damper and fuel tank.
Remove the fuel tank from the frame.
Note:
Refer to P115 and P116 for detailed disassembly and
assembly diagram.
9.3.1 Installation
Install the tank in the reverse order of removal.
Installation torque:
Seat cushion mounting bolt 22-29 N·m
Fuel tank mounting bolt 5 - 9 N·m
To Next Page
Loading...