EasyManuals Logo

Worx Generic QJ125-26A User Manual

Worx Generic QJ125-26A
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #149 background imageLoading...
Page #149 background image
Measure the thickness of friction plate with a vernier caliper.
Allowable limit: Replace it when it is below 2.6mm.
14.4 Disassemble Main Shaft and Countershaft
Inspection
Check respectively wear of tooth surface and drive pawls. If
they are seriously worn or damaged, replace them.
Remove bearing and oil seal on left crankcase.
Check if bearing and oil seal are injured. Replace if necessary.
齿面
传动爪
Drive pawls
Thickness
Tooth
Surface

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Worx Generic QJ125-26A and is the answer not in the manual?

Worx Generic QJ125-26A Specifications

General IconGeneral
BrandWorx
ModelGeneric QJ125-26A
CategoryMotorcycle
LanguageEnglish