VI Motorcycle Exterior
Disassemble the motorcycle body in the following sequence:
Seat cushion assembly → Left and right protecting plate assemblies → Left and right tail covers → Left and right
hanger → Left and right hanger →
↓
Left and right pedals → Front mudguard brace panel → Front mudguard → Rear mudguard assembly → Rear rail →
Rear tail cover connectiong board → Tail lamp → Tail lamp support
* Attention
Do not damage exterior parts during assembly and disassembly.
Do not damage the pawls on the exterior parts of the vehicle body during disassembly and assembly.
Align built-in panel and cover plate to their grooves respectively.
Correctly install paw of each part during combination.
Do not damage the fittings during exterior part installation.
To Next Page
Loading...