4.3 Headlamp Bulb Replacement
4.3.1 Removal
Screw off with a wrench locknut（1） of headlamp and take
down the headlamp.
Pull out socket of headlamp adapter and remove the rear
cover. Release circlip and take out of the lamp adapter.
* Attention
When the bulb is lit, keep you hands and inflammable
materials some distance away from it. Lighting bulb is hot;
touch it when it cools down.
4.3.2 Installation
Install the new bulb, adapter and headlamp rear cover.
Tighten the new bulb into the socket.
Avoid touching bulb glass with your bare hands during installation and staining it with oil, which may affect
transparency, service life and
luminous flux of bulb.
If oil is adhered to the bulb, clean it with a cloth moistened with alcohol or highly volatile rubber solution.
Install headlamp assembly.
4.4 Front turn signal lamp bulb replacement
4.4.1 Removal
Disconnect wire to turn signal lamp.
Screw off self-tapping screw（2）on the turn signal lamp.
Remove the bulb socket from the lamp.
Remove the bulb from lamp adapter.
4.4.2 Installation
Install the bulb in the reverse order of removal.
To Next Page
Loading...
Need help?
General