7.2.2 Wobbly Direction Handle
Damaged handle bearing.
Not enough tyre pressure.
Front fork bent, front wheel shaft bent.
Distorted and crooked front wheel tyre.
7.2.3 Wobbly Front Wheel
Distorted wheel
Worn front wheel bearing
Defective front tyre
7.2.4 Difficult Rotation of Wheel
Shaft or bearing seat fault
Braked
7.2.5 Noisy Front Shock Absorber
Friction sound of shock absorber protecting plate
Loosened bolts on the shock absorber.
7.3 Front Wheel
7.3.1 Disassembly
Attention:
Stand the motorcycle reliably.
Screw off speedometer mounting bolts and remove
speedometer cable.
Screw off front shaft locknuts.
Remove front shaft (1), take down bearing seat assembly (2) and
front wheel.
Screw off bolts and remove front mudguard and lead wire of
odometer.
Remove front brake hose.
Remove oil seal assembly (10) and bearing (5) with an oil seal
remover and a bearing remover respectively.
* Note: Refer to Page 95 of the manual for detailed QJ125
Motorcycle front wheel disassembly and assembly diagram.
7.3.2 Inspection
7.3.2.1 Shaft Curvature Inspection
To Next Page
Loading...