* Attention:
Hammered-out bearing cannot be reused. Replace it with a new
one.
Remove bearing and oil seal with special tools.
Remove bearing on right crankcase.
Check if bearing is injured. Replace if necessary.
* Attention:
Hammered-out bearing cannot be reused. Replace it with a new
one.
Remove bearing and oil seal with special tools.
Main shaft and countershaft combination
* Attention: Apply each gear and shaft with lubricating grease evenly at combination.
Make sure there is no stuck after combination.
Note:
Install the crankcase in the reverse order of removal.
Bearing hole, oil seal hole
To Next Page
Loading...