Worx Generic QJ125-26A - Starting Motor Does Not Run

Symptom: Starting motor does not run
Diagnosis procedures
Electric horn does not sound or sound
weakly. Turn signal lamp is dim.
Electric horn sounds loudly.
Turn signal lamp is bright.
Battery is low or the wire terminal
connected with battery is poorly
contacted.
Grasp brake handle bar (autoscooter), or shift
transmission into neutral, or grasp clutch handle
bar, push starter button.
Starter motor does not run.
Turn on ignition switch; press horn button or slide
turn signal lamp switch.
Push starter button and the “click” sound from
starter relay cannot be heard.
Push starter button and a “click” sound from
starter relay can be heard.
Disassemble the connector of starter relay from cables of
the whole vehicle; connect the two hatching wires from
relay coil to negative and positive terminals of battery with
two
p
ieces of wires.
Use a screwdriver or a piece of thick wire to
connect battery terminal on the starter relay with
starter relay terminal.
After connection,
starter motor works.
After short circuit,
starting motor runs
normally
After connection, the
starter motor does not
run either and no click
sound can be heard from
starter relay.
After short circuit,
starting motor does not
run.