Maintenance Rules
While repairing and servicing, use tools of metric system as possible. Incorrect tools may damage the motorcycle.
Before taking down or opening protecting plate for repair work, please clean the dirt on the external surfaces of
components or combination parts and prevent the dirt from falling into engine, chassis or braking system
After disassembly and before measuring friction, please clean the
components and blow them with compressed air.
Plastic parts may age and deteriorate, which are apt to be damaged by
solvent or oil. Check before re-installation and replace if necessary.
To loose component with many assembling units, it shall start from
external to internal and loosen smaller assemblies first. The
complicated assemblies such as transmission case shall be put in
proper assembling order for easy assembly in the future.
Pay special attention to the key fitting position before disassembly.
The components that are not used any more shall be replaced on time
before disassembly.
To Next Page
Loading...
Need help?
General