Page 5-40 Publication No. 150-041118
Section 5 – Configuration and Programming Rev. A
Sep 2001
SETUP: 2=NEXT 3=BACK
C-5000 SIDETONE -NO
• This page only appears if system encryption is available. Use the cursor/value knobs to tell the C-5000 if it
should use side-tones. Press the MODE button to display the next menu page.
SETUP: 2=NEXT 3=BACK
C-5000 DEEMPH -NO
• This page only appears if system encryption is available. Use the cursor/value knobs to tell the C-5000 if it
should use de-emphasis. Press the MODE button to display the next menu page.
MISC SETUP
HOME=EXIT 2=REVIEW
• Press the HOME button to exit the miscellaneous configuration menu pages, or the MODE button to review
current settings.
Configuring the C-5000 Using a PC
Wulfsberg highly recommends using the PC based Remote Programmer (RP) software to specify the C-5000’s
configuration. The Remote Programmer software offers several advantages over using the C-5000’s front panel.
• Allows you to specify a C-5000’s configuration in less time.
• Enhanced error checking reduces the likelihood of specifying an incorrect configuration.
• A configuration can be specified once and loaded to multiple C-5000’s, saving huge amounts of data entry time.
• Configurations can be saved, archived, and backed-up, reducing the likelihood of lost data.
• Configurations can be sucked out of C-5000’s as well, saving data entry time on existing configurations.
Refer to the Remote Programmer software’s user manual for details on how to specify C-5000 configurations in RP.
Downloading a Configuration from RP into the C-5000
The C-5000 continuously polls the data port on the front panel for incoming data, so all the user has to do is initiate
the download from RP. Refer to RP’s user manual for details on how to initiate a download. Once the
communication channel is open, the C-5000’s display will change to the following.
To Next Page
Loading...
Need help?
General
