Wulfsberg C-5000 User Manual

C-5000 COMMUNICATION MANAGEMENT CONTROLLER
INSTALLATION MANUAL
Publication No. 150-041118 Page 5-19
Rev. A Section 5 – Configuration and Programming
Sep 2001
• Ensure you are on the HOME PAGE.
• Select the desired channel for radio 1.
• Select the desired channel for radio 2.
• Press the MODE button until the following display page appears.
PRESS ENTER BUTTON
FOR SIMULCAST MODE
• Press the ENTER button. The following illustrates the SIMULCAST PAGE for radio 1 on channel 1 and radio
2 on channel 2.
SIMULCAST MODE
1 ..1 2 ..2
• Press the HOME button to exit simulcast mode and return to the HOME PAGE.
• Use either RT1 or RT2 mic position on the audio selector panel and initiate a transmission. Both Radios will
transmit at the same time.
Relay Operation
Relay Mode allows your aircraft’s C-5000-based transceiver system to function as a cross-band repeater. If a Relay
Mode link is established between two locations, a message received from one location is automatically retransmitted
to the other. You can establish relay operation as follows.
• Ensure you are on the HOME PAGE.
• Select the desired channel for radio 1.
• Select the desired channel for radio 2.
• Press the MODE button until the following display page appears.

Wulfsberg C-5000 Specifications

General

Brand	Wulfsberg
Model	C-5000
Category	Controller
Language	English