C-5000 COMMUNICATION MANAGEMENT CONTROLLER
INSTALLATION MANUAL
Publication No. 150-041118 Page 5-3
Rev. A Section 5 – Configuration and Programming
Sep 2001
Steps to Successful Setup and Operation
While we would like to pull products out of the box and immediately start to use them, this system is one that takes
a little work to get to that point. The following checklist will help installers and initial users setup the C-5000 and
RT-5000.
1. Connect C-5000 to the transceivers. Note part numbers of the Control head and all transceivers.
C-5000 Part Number = 31300-1X02- ____________
Radio #1 Model # = ___________________ Part Number = ______________________
Radio #2 Model # = ___________________ Part Number = ______________________
2. Configure the C-5000 using the steps outlined in the manual. You must know the last four digits of the C-5000
part number and the last four digits of any RT-5000’s or the model type of any Flexcomm/Flitecomm
Transceiver.
3. If Radio #1 is an RT-5000 that has a MTM Guard Receiver (-06XX or greater) connect a PC to the 9-pin
programming port of the RT-5000 and run the Motorola RSS software.
4. Put the C-5000 in RSS mode for radio #1 and select the first ITM to appear.
5. Using the RSS software, read the codeplug out of the ITM.
6. Modify system settings for your application. Program personalities. Assign zone/Channels. These steps
require significant knowledge of the Motorola software. We encourage enlisting the help of someone familiar
with Motorola RSS software to successfully program the ITM.
NOTE: ZONE 1 CHANNEL 1 MUST BE ASSIGNED TO A PERSONALITY THAT HAS DIFFERENT
RECEIVE AND TRANSMIT FREQUENCIES!!!!!
7. Save the modified codeplug to disk and load it into the ITM.
8. Make a listing of all ZONE/CHANNELS Information needed by the C-5000 preset channel programming.
Zone ______ Channel ______
RX Frequency = ______________________ RX Tone = __________
TX Frequency = ______________________ TX Tone = __________
Modulation = ______________(FM,P25,TRK)
9. Do the above for the second ITM if there is one in Radio #1
10. Do the above for Radio #2 only if its an RT-5000 with an MTM Guard (-06XX or greater)
11. Using the front panel or better yet the Wulfsberg RP software, program all preset channels including the ones
programmed into each ITM module in the steps above.
12. Using a communication analyzer or over the air test, verify that each radio and channel operates properly.
To Next Page
Loading...
Need help?
General
