Page 5-38 Publication No. 150-041118
Section 5 – Configuration and Programming Rev. A
Sep 2001
SYS #2:2=NEXT 3=BACK
ENTER=SETUP GUARD #2
• This page only appears if a second guard is present. Press the ENTER button to configure the second Guard
channel. Refer to the preset channel programming section for details on the menu pages that appear. Press the
MODE button to display the next menu page.
SYS #2:2=NEXT 3=BACK
TONE BOARD CTCSS-NO
• Use the cursor/value knobs to tell the C-5000 if a CTCSS tone board is present. Press the MODE button to
display the next menu page.
SYS #2:2=NEXT 3=BACK
TONE BOARD DCS-NO
• Use the cursor/value knobs to tell the C-5000 if a DCS tone board is present. Press the MODE button to display
the next menu page.
SETUP RADIO #2
HOME=EXIT 2=REVIEW
• Press the HOME button to exit the radio setup menu pages, or press the MODE button to review the current
settings.
Setting Passwords
This section drills down into the password setup sub-menu pages. Refer to the section on configuring the C-5000
for details on how to reach these menu pages. This section assumes we want to change password 1. The process is
the same for password 2. We pick up at the following display page.
SETUP: 2=NEXT 3=BACK
ENTER=CHG PASSWORD 1
• Press the ENTER button to begin the password changing process. The display will appear as follows.
To Next Page
Loading...
Need help?
General
