EasyManua.ls Logo

Wulfsberg C-5000 - SECTION 1 - INTRODUCTION; Using This Manual; SECTION 2 - SYSTEM INSTALLATION; SECTION 3 - MECHANICAL INSTALLATION

Default Icon
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C-5000 COMMUNICATION MANAGEMENT CONTROLLER
INSTALLATION MANUAL
Publication No. 150-041118 Page 1-1
Rev A Section 1 - Introduction
Sep 2001
SECTION 1 - INTRODUCTION
IMPORTANT
This manual contains information pertaining to the installation of the C-5000
Communication Management Controller with FLEXCOMM II and FLEXCOMM I.
FLEXCOMM II consists of the RT-5000 Transceiver, appropriate antennas, and optional
equipment as required. FLEXCOMM I consists of the RT-9600 Transceiver, RT-9600F
Transceiver, RT-7200 Transceiver, and optional combinations of up to three of the
following FLEXCOMM Transceivers: RT-30, RT-118, RT-138(F), RT-406F, RT-450,
appropriate antennas, and optional equipment as required. The C-5000 can also
interface with combined applications of FLEXCOMM II and FLEXCOMM I, i.e., a hybrid
RT System configuration that consists of both RT-5000 and FLEXCOMM I Transceivers.
1. Using This Manual
This manual is divided into the following sections:
SECTION 1- INTRODUCTION
This section contains an overview of the contents of this manual and lists the components
installed in FLEXCOMM I and FLEXCOMM II systems using the C-5000.
SECTION 2 - SYSTEM INSTALLATION
This section covers the general system characteristics, interface capabilities and power
requirements.
SECTION 3 - MECHANICAL INSTALLATION
This section contains system component dimensions, the racking requirements, weights, and
component installation data.
SECTION 4 - FLEXCOMM II ELECTRICAL INSTALLATION
This section contains the wiring information to install the C-5000 Control Unit with the
FLEXCOMM II Transceiver in an aircraft.
SECTION 5 - FLEXCOMM I ELECTRICAL INSTALLATION
This section contains the wiring information to install the C-5000 Control Unit with the
FLEXCOMM I Transceiver in an aircraft.
SECTION 6 - SYSTEM CONFIGURATION AND PRESET CHANNEL PROGRAMMING
This section contains the system configuration and preset channel programming procedures
for the system.
SECTION 7 - SYSTEM CHECKOUT
This section contains checkout procedure for the system after installation.

Table of Contents

Related product manuals