CAMERA SYSTEM (LooksCAM2) 38 www.xenosys.co.kr
4. If you need expert’s help, contact to manufacturer or professional distributor.
TRANSPORTATION
1. To protect LooksCAM2 from any damage in transportation, pack it by plastic bubble wrap or
shipping box.
2. Load LooksCAM2 boxes up and down evenly by handcart and any vehicle trunk to transport.
3. When you carry LooksCAM2 by hand, hold it with two hands firmly and disconnect charger, and
power cord from the main body for safe transportation.
STORAGE
1. Maintain the following conditions for storing main products & components.
Environment for Operating & Storage
Environment for Transportation & Storage (Non-operating)
- External box marking will be as follows.
1. Do not pull out, twist, nor bend excessively the power cord.
2. Wind up the power cord loosely, and store it by using the rubber bandage or cable tie.
3. Do not expose the main body to excessive shock, direct ray of light and high temperature which
may cause the defective reason.
4. Caution for battery storage: As Li-ion battery is small-sized with high power, if it is stored fully
charged condition for a long time, the battery lifespan can be reduced.
① Store it under half-charged condition in case of non-use immediately.
② Store the battery with separated from the main body in case of long-time no use.
③ Recommend to keep it in the dry condition with ambient temperature range of +15℃ - +25℃.
Keep away from too hot or extremely cold places.
To Next Page
Loading...