13 Problem Solving
120 Xerox CopyCentre/WorkCentre 118 System Administration Guide
A network error occurs on the
network between the client
and the machine.
Use the PING command to
check the communication
status.
Check the error.
The printer entry setting is
not correctly defined on the
client.
Check the printer entry
setting on the client. Check
the /etc/printcap file of the
client or use the lpstat
command to troubleshoot.
Define the correct printer
entry setting.
The system is in offline. Check if the online lamp is
off.
Exit the pause or the
machine setting mode, and
then check if the online lamp
comes on.
The print data size sent in
one print command exceeds
the buffer memory size (in
spool mode).
Check the upper limit of the
receiving data size, and then
compare it with the size of
print data to be sent as one
job.
<Action -1>
When the print data size
exceeds the maximum
receiving data size in one file,
divide the file into files
smaller than the maximum,
then re-send the print
request.
<Action -2>
When the print data size
exceeds the maximum
receiving data size in multiple
files, reduce the number of
files to be printed at one time.
A fault occurred during print
processing.
Check the LPD error
message displayed on the
control panel.
Switch the machine off and
on.
The specified transmission
speed is different from the
transmission speed of the
network.
Check whether the
transmission speed is
specified correctly.
Specify the correct
transmission speed.
The client and machine are in
different rings connected via
a bridge, and the source
routing is inactivated.
Check whether the source
routing is specified correctly.
Activate the source routing.
The data format of the print
job does not match the print
environment of the client
(print data sent from the
client contains TBCP).
–
Specify PSASC as the printer
name.
Cause Confirmation Method Action
To Next Page
Loading...
Need help?
General