2 Product Overview
14 Xerox CopyCentre/WorkCentre 118 System Administration Guide
NOTE: Depending on the configuration, the Document Glass Cover is attached
instead of the Document Feeder. A maximum of three optional paper trays can be
attached.
Power On/Off
Powering On
Make sure that the machine is connected to a suitable power supply and that the power
plug is firmly connected to the electrical outlet. For more information, refer to the
Specifications chapter of the User Guide.
The machine is ready to make copies about 25 seconds after the power is switched on.
1. Press the power switch to the <I>
position.
NOTE: If the machine does not start up,
check that the <RESET> button on the side
of the machine is in the reset position.
Powering Off
If the Fax option is installed, make sure that the <Jobs in Memory> indicator on the
control panel is off before you switch off the machine. If you switch off the machine
while the <Jobs in Memory> indicator is lit for more than hour, all stored documents will
be deleted. After charging for 30 hours, the machine is able to keep stored documents
for an hour.
NOTE: Wait at least 20 seconds between powering the system on and off. Failure to
do this could cause damage to the disk.
To Next Page
Loading...
Need help?
General