Xerox Copycentre C118 System Administration Guide

SMB Installation
Xerox CopyCentre/WorkCentre 118 System Administration Guide 67
NOTE: You cannot enter 127, 254, or 255 into the first section of the format for the
gateway address.
7. Press the <Log In/Out> button.
NOTE: If you wish to filter access to the machine from the client computers, activate
the IP Filter. The [Filter] screen is located in the same layer as the [TCP/IP Settings]
screen.
Workstation Setup
Install the print driver on the client computer. Refer to the HTML documentation in
CentreWare Utilities CD-ROM.
Test Print
Make sure that the machine has been installed on the network correctly by submitting
a test print from a client workstation. Perform the following steps.
1. Open a document on a client workstation.
2. Select the machine as the printer.
3. Print the document on the machine and verify that it prints correctly.
4. Make sure that the print driver is installed on every workstation that will be sending
jobs to the machine.
5. Repeat the test for all workstations that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to Problem Solving chapter for assistance.

Xerox Copycentre C118 Specifications

General

Brand	Xerox
Model	Copycentre C118
Category	Copier
Language	English