9USB Port
82 Xerox CopyCentre/WorkCentre 118 System Administration Guide
USB Port Environment
System configuration
The machine can be connected directly to the USB port of a host workstation. A
document file can be sent from the host workstation via the USB port to the machine
for printing. Other workstations can be connected via a network to the host workstation.
Each workstation has a queue that can hold a number of files.
The document file is sent from the queue in the workstation to the queue in the host
workstation, and then onto the queue in the machine to be printed.
Target computers
The following computers support printing through the USB port.
• Windows 2000/Windows XP/Windows Server 2003
• Mac OS X 10.2.x
NOTE: The optional PostScript Kit is required when you print from Macintosh.
USB Port Installation
Follow these installation procedures for using the machine on a USB port.
Installation Procedure
There are three stages required to install the machine on a USB port.
USB Port Communication Setup
This requires the machine to be set up for USB port printing.
Workstation Setup
This requires the workstation to be configured to print to the machine.
Test Print
A print job should be submitted to make sure that the machine has been installed and
configured correctly.
To Next Page
Loading...
Need help?
General