7 TCP/IP (LPD or Port9100)
72 Xerox CopyCentre/WorkCentre 118 System Administration Guide
TCP/IP (LPD or Port9100) Environments
System configuration
As the machine supports the LPD and Port9100 protocol, you can print directly from a
Windows computer.
When printing from Windows 95/Windows 98/Windows Me computers through the LPD
port, use our TCP/IP Direct Print Utility. This tool is installed together with the print
drivers. When printing from Windows NT 4.0/Windows 2000/Windows XP/Windows
Server 2003 computers, use the OS standard LPR port.
When printing through Port9100, change the necessary settings on the computers.
The transport protocol for LPD and Port9100 can be TCP/IP.
You will also need to set up the IP address on the machine and the Windows
computers.
NOTE: Windows NT 4.0 does not support printing through Port9100.
Target computers
The following computers support printing through LPD or Port9100.
NOTE: The optional PostScript Kit is required when you print from Macintosh.
TCP/IP (LPD or Port9100) Installation
This section describes how to set up the machine to use the LPD and Port9100
protocol.
Installation Procedure
There are three stages to enable printing to the machine through LPD or Port9100.
Connection OS Protocol
LPD port Windows 95
Windows 98
Windows Me
Windows NT 4.0
Windows 2000
Windows XP
Windows Server 2003
Mac OS X
TCP/IP
Port9100 Windows 2000
Windows XP
Windows Server 2003
TCP/IP
To Next Page
Loading...
Need help?
General