Xerox Copycentre C118 System Administration Guide

Xerox CopyCentre/WorkCentre 118 System Administration Guide 63
6 Microsoft Networking
This chapter explains how to set up the machine to operate on a Microsoft network. The
following information is provided.
Information Checklist – page 63
SMB Environments – page 64
SMB Installation – page 65
Installation Procedure – page 65
Network Communication Setup – page 65
Workstation Setup – page 67
Test Print – page 67
Changing the Settings – page 68
Procedure – page 68
Setting Format of config.txt – page 69
Information Checklist
Before starting the Microsoft networking installation procedures, make sure that the
following items are available or have been performed.
If problems are encountered during the installation, refer to Problem Solving chapter for
assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational Microsoft network is required. These procedures
are not designed to install a Microsoft network.
Customer
Obtain and record the following information, if required:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
Customer
Print driver for the machine Customer

Xerox Copycentre C118 Specifications

General

Brand	Xerox
Model	Copycentre C118
Category	Copier
Language	English