Xerox Copycentre C118 System Administration Guide

SMB Installation
Xerox CopyCentre/WorkCentre 118 System Administration Guide 65
SMB Installation
This section describes the installation procedure for using the machine on an SMB
network.
Installation Procedure
The installation procedure is as follows.
Network Communication Setup
When using NetBEUI:
Set the SMB port to [Enable] using the control panel or CentreWare Internet
Services.
When using TCP/IP:
Set the SMB port to [Enable] using the control panel or CentreWare Internet
Services. Set the IP address on the control panel.
Workstation Setup
Install the print driver on the computer.
Test Print
A print job should be submitted to make sure that the machine has been installed and
configured correctly.
Network Communication Setup
This procedure is used to set up the network communication parameters of the
machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
NOTE: CentreWare Internet Services can also be used to configure the machine.
Refer to CentreWare Internet Services chapter on page 91.
First, enable the SMB port.
1. Connect the machine to the network.
2. Press the <Log In/Out> button.
3. Select [System Settings].
4. Enter the password using the numeric keypad and then select [Confirm].
5. Select [Print Settings] and then press the <Enter> button.
6. Press the <Enter> button on the [Network/Port] screen.

Xerox Copycentre C118 Specifications

General

Brand	Xerox
Model	Copycentre C118
Category	Copier
Language	English