Xerox CopyCentre/WorkCentre 118 System Administration Guide 39
4 UNIX TCP/IP
This chapter explains how to set up the machine to operate in a UNIX TCP/IP
environment. The UNIX Workstation Operating Systems (OS) supported are Solaris,
SunOS, and HP-UX. The following information is provided.
Information Checklist – page 39
UNIX TCP/IP Environments – page 40
UNIX TCP/IP Installation – page 40
Installation Procedure – page 40
Network Communication Setup – page 41
Workstation Setup – page 42
Test Print – page 47
Printing – page 48
Solaris/HP-UX – page 48
SunOS – page 50
Printer Status – page 52
Solaris/HP-UX – page 52
SunOS – page 53
-C Option – page 54
Information Checklist
Before installing the UNIX TCP/IP features on the machine, make sure that the
following items are available or have been performed.
Item By
An existing operational network utilizing a UNIX TCP/IP protocol is
required. These steps are not designed to install the UNIX TCP/IP
network.
Customer
SunOS 4.1.x, Solaris 1.x, 2.x, 7.x, 8.x, 9.x, HP-UX 9.x, 10.x or 11.x Customer
Make sure that the correct IP Address is being used for the machine. Customer
Make sure that the Gateway Address is set correctly. Customer
Make sure that the Subnet Mask is set correctly. Customer
Make sure that the Host Name is set correctly. Customer
Test the copy and fax features of the machine, to make sure that they are
installed fully and functioning correctly.
Customer
To Next Page
Loading...
Need help?
General