Xerox Copycentre C118 System Administration Guide

TCP/IP (LPD or Port9100) Installation
Xerox CopyCentre/WorkCentre 118 System Administration Guide 75
NOTE: If you wish to filter access to the machine from the client computers, activate
the IP Filter. The [Filter] screen is located in the same layer as the [TCP/IP Settings]
screen.
Workstation Setup
Install print drivers on each client workstation that will be sending print jobs to the
machine, and map to the machine as a printer. Refer to the HTML documentation in
CentreWare Utilities CD-ROM or documentation provided with the optional PostScript
Kit.
Test Print
To make sure that the machine has been installed on the network correctly, a test print
should be submitted from a client workstation. Perform the following steps.
1. Open a document on a client workstation.
2. Select the machine as the printer to which the selected document will be sent.
3. Print the document on the machine and verify that it prints correctly.
4. Make sure that the driver is installed on every workstation that will be sending jobs
to the machine.
5. Repeat the test for all workstations that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for assistance.

Xerox Copycentre C118 Specifications

General

Brand	Xerox
Model	Copycentre C118
Category	Copier
Language	English