Xerox Phaser 3320DN

Machine Parts and Connection Ports
Xerox Phaser 3320DN/3320DNI
System Administrator Guide
17
4. Holding the memory module by the edges, align the memory module on the slot at about a 30-
degree tilt. Make sure that the notches of the module and the grooves on the slot fit each other.
Note The notches and grooves illustrated may not match those on an actual memory module
and its slot.
5. Press the memory module into the slot with care until you hear a ‘click’.
6. Do not press the memory module strongly or the module may be damaged. If the module does
not seem to fit into the slot properly, carefully try the previous procedure again.
7. Replace the control board cover.
8. Reconnect the power cord and machine cable and turn the machine on.