TCP/IP
Xerox Phaser 3320DN/3320DNI
System Administrator Guide
24
TCP/IP
These instructions show you how to configure the following:
• TCP/IP v4 and v6
• Domain Name
• DNS
• Zero Configuration Networking
The machine supports TCP/IP versions 4 and 6. IPv6 can be used instead of or in addition to IPv4.
IPv4 and IPv6 settings can be configured directly at the machine, or remotely, via a web browser using
Internet Services. To configure TCP/IP settings using Internet Services, refer to Configure TCP/IP
Settings using Internet Services on page 26.
Configure Static IPv4 Addressing at the Machine
Information Checklist
Before starting please ensure that the following items are available and/or the tasks have been
performed:
• Existing operational network utilizing the TCP/IP protocol.
• Ensure that the machine is connected to the network.
• Static IP Address for the machine.
• Subnet Mask Address for the machine.
• Gateway Address for the machine.
• Host Name for the machine.
Procedure
Enter a Static IP Address:
1. Press the Menu button on the control panel.
2. Press the arrow buttons to scroll to Network Setup; press OK.
3. Enter the Administrator Password using the arrow buttons. The default is 1111. Refer to Entering a
password: on page 14.
4. Press the OK button.
5. Press the arrow buttons to select TCP/IP (IPv4); press OK.
6. Press the arrow buttons to select Static; press OK.
7. Press the arrow buttons to select IP Address; press OK.
8. Enter the IP Address using the arrow buttons and press OK.
9. Enter details for Subnet Mask using the arrow buttons; press OK.
10. Enter details for Gateway using the arrow buttons; press OK.
11. The Saved screen will display and return to the TCP/IP (IPv4) menu.
To Next Page
Loading...
Need help?
General