Xerox Phaser 3320DN System Administrator Guide

Properties
Xerox Phaser 3320DN/3320DNI
System Administrator Guide
91
SLP
The SLP page allows you to configure the SLP protocol (Service Location Protocol) on the device.
1. In the Network Settings link select the SLP link.
2. Select Enable to enable the SLP Protocol.
3. Enter the required information to configure the following settings:
• Scope 1, 2 and 3
• Message Type
•Multicast Radius
• Registration Lifetime
4. Select Apply to save the settings.
UPnP
The UPnP page allows you to configure the SSDP protocol (Simple Service Discovery Protocol) on the
device.
1. In the Network Settings link select the UPnP link.
2. Select Enable to enable the SSDP Protocol.
3. Enter the required information for SSDP TTL.
4. Select Apply to save the settings.
mDNS
The mDNS page allows you to enable the MDNS protocol (Multicast DNS) on the device. This protocol
is used in Bonjour (formerly Rendezvous) from Apple.
1. In the Network Settings link select the mDNS link.
2. Select Enable to enable the mDNS Protocol.
3. Select Apply to save the settings.
SNMP
The SNMP page allows you to configure the SNMP (Simple Network Management Protocol) v1, v2 and
v3 settings on the device. For instructions, refer to SNMP on page 69.
Outgoing Mail Server (SMTP)
The Outgoing Mail Server (SMTP) page allows you to configure the SMTP (Simple Mail Transfer
Protocol) settings on the device.
1. In the Network Settings link select the Outgoing Mail Server (SMTP) link.
2. In the Simple Mail Transfer Protocol (SMTP) area:
a. Enter the IP or host name of the SMTP Server.

Xerox Phaser 3320DN Specifications

General

Brand	Xerox
Model	Phaser 3320DN
Category	Printer
Language	English