4-42
Phaser 3635MFP
REP 28.2
Draft 4
Repairs and Adjustments
REP 28.2 Outbin Assembly
Parts List on PL 28.10
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1. Remove the DADF, PL 5.10 Item 1.
2. Remove the UI assembly, REP 2.1.
3. Remove the left cover, right cover and rear cover, REP 28.1.
4. Remove the scanner assembly, REP 14.1.
5. Remove the stapler assembly, PL 11.10 Item 4.
6. Disconnect the following harnesses from the Connection PWB:
• CN7
• CN1
• CN2
7. Remove the exit cover assembly, PL 28.10 Item 2.
8. Disconnect the following harnesses from the Main PWB:
• CN7
• CN14
• CN15
• CN26
9. Prepare to remove the outbin assembly, Figure 1.
Figure 1 Preparation
CAUTION
Take care not to damage the main PWB location spigot when removing the outbin, refer to Fig-
ure 1. Also, take care not to move the exit roll and idlers.
10. Remove the outbin assembly, Figure 2.
1
Remove 6 screws marked A.
Main PWB location spigot
To Next Page
Loading...
