Basic Regulations
Xerox has tested this printer to electromagnetic emission and immunity standards. These standards
are designed to mitigate interference caused or received by this printer in a typical office
environment.
EENNEERRGGYY SSTTAARR
®®
QQuuaalliiffiieedd PPrroodduucctt
The WorkCentre
®
3345 Printer is ENERGY STAR
®
qualified under the ENERGY
STAR Program Requirements for Imaging Equipment.
The ENERGY STAR and ENERGY STAR mark are registered United States trademarks. The
ENERGY STAR Imaging Equipment Program is a team effort between the United States,
European Union, and Japanese governments and the office equipment industry to
promote energy-efficient copiers, printers, fax, multifunction printers, personal computers,
and monitors. Reducing product energy consumption helps combat smog, acid rain, and
long-term changes to the climate by decreasing the emissions that result from
generating electricity.
Xerox ENERGY STAR equipment is preset at the factory. Your printer is delivered with the
timer, for switching to Power Saver Mode from the last copy/print out, set at 1 or 2
minutes.
For a more detailed description of this feature, refer to the Power Saver Mode section of
this guide.
UUnniitteedd SSttaatteess FFCCCC RReegguullaattiioonnss
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in
accordance with these instructions, it may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his/her own expense.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not approved by Xerox can void the authority of the user
to operate this equipment.
Note: To ensure compliance with Part 15 of the FCC rules, use shielded interface cables.
216
Xerox
®
WorkCentre
®
3335/3345 Multifunction Printer
User Guide
Regulatory Information
To Next Page
Loading...
Need help?
General
