Xerox WorkCentre 5325 Administrator's Guide

Initial Setup
WorkCentre 5300 Series Multifunction Printer
System Administrator Guide
16
Manually Setting the Printer’s Ethernet Interface Speed
The printer’s Ethernet interface automatically detects the speed of your network. If your network is
connected to another auto-sensing device, such as a hub, the hub may not detect the correct speed.
Refer to the configuration page to make sure the printer has detected the correct speed of your
network. To view the configuration page, see Accessing the Configuration Report on page 17.
To manually set the speed of the printer’s Ethernet interface:
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch System Settings > Connectivity & Network Setup > Protocol Settings.
3. Touch Ethernet Rated Speed and touch Change Settings.
4. Select the Speed to match the speed set on your hub or switch.
5. Touch Save, then touch Close.
Assigning a Network Address
By default, the printer automatically acquires a network address from a DHCP server. To assign a static
IP address, configure DNS server settings, or configure other TCP/IP settings, see TCP/IP on page 22.

Xerox WorkCentre 5325 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed (Black)	Up to 25 ppm
Print Resolution	Up to 1200 x 1200 dpi
Standard Paper Capacity	1, 090 sheets
Max Paper Capacity	5, 090 sheets
Processor	533 MHz
Copy Speed	Up to 25 cpm
Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Duplex Printing	Automatic
Paper Sizes	A4, A5
Memory	256 MB
Hard Drive	80 GB
Connectivity	USB 2.0, Ethernet
Scan Destinations	Email, Network, USB
Fax Transmission Speed	33.6 Kbps
Operating System Compatibility	Windows, macOS, Linux