Xerox WorkCentre 5325 Administrator's Guide

Network Configuration
WorkCentre 5300 Series Multifunction Printer
System Administrator Guide
30
Raw TCP/IP Printing
Raw TCP/IP is a printing method used to open a TCP socket-level connection over Port 9100, to stream
a print-ready file to the printer's input buffer. It then closes the connection either after sensing an End
Of Job character in the PDL or after expiration of a preset time-out value. Port 9100 does not require
an LPR request from the computer or the use of an LPD running on the printer. Port 9100 is selected in
Windows as the Standard TCP/IP port.
Enabling Port 9100
Note: TCP/IP must be enabled before Port 9100 is enabled.
1. In CentreWare IS, click Connectivity > Port Settings.
2. Next to Port 9100, select Enabled.
Configuring Port 9100
1. In CentreWare IS, click Properties > Connectivity > Protocols > Port 9100.
2. Next to TCP-MSS Mode, select Enabled if necessary.
Note: TCP-MSS settings are common for LPD and Port 9100.
3. If TCP-MSS mode is enabled, under IPv4, type the IP addresses for Subnet 1, 2, and 3.
4. Ensure that the TCP Port Number is set to 9100.
5. Set the End of Job Timeout to the desired number of seconds between 0 and 1800 before
processing a job with an End of Job character. The default time is 300 seconds.
6. Click Apply.

Xerox WorkCentre 5325 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed (Black)	Up to 25 ppm
Print Resolution	Up to 1200 x 1200 dpi
Standard Paper Capacity	1, 090 sheets
Max Paper Capacity	5, 090 sheets
Processor	533 MHz
Copy Speed	Up to 25 cpm
Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Duplex Printing	Automatic
Paper Sizes	A4, A5
Memory	256 MB
Hard Drive	80 GB
Connectivity	USB 2.0, Ethernet
Scan Destinations	Email, Network, USB
Fax Transmission Speed	33.6 Kbps
Operating System Compatibility	Windows, macOS, Linux