Security
WorkCentre 5300 Series Multifunction Printer
System Administrator Guide
52
To configure authentication using Xerox Secure Access:
1. In CentreWare IS, click Properties > Security > Authentication Configuration.
2. On the Authentication Configuration page, next to Login Type, select Xerox Secure Access.
3. Select Enabled next to Print Stored File from Folder, or Enabled next to Folder to PC/Server
Enabled to enable these services.
4. Select Enabled next to Non-account Print to allow users without accounts to access the printer.
5. Click Apply, then click Reboot Machine.
6. After the printer restarts, refresh your browser and navigate back to the Authentication
Configuration > Step 1of 2 page, and click Next at the bottom of the page.
7. Next to Authentication System, click Configure.
8. On the Authentication System page select Authentication Agent from the drop-down list.
9. Type the Server Response Time-Out, and the Search Time-Out.
10. Select Enabled next to Assign UPN (User Principal Name) if desired.
11. Click Apply to accept the changes or Undo to retain the previous settings.
12. Click Reboot Machine.
Configuring Xerox Secure Access Login Settings
1. In CentreWare IS, click Properties > Security > Remote Authentication Servers Xerox Secure
Access Settings.
2. Type the Default Prompt text and Default Title text.
3. Select Enabled next to Local Login to allow users to type their credentials at the control panel.
4. Select Enabled next to Get Accounting Code to allow the printer to get the user’s accounting
code from a network accounting server when the user logs in at the control panel. Network
authentication and network accounting must be configured. For details, see Network
Authentication on page 50, and Network Accounting on page 133. If this setting is not enabled,
the user must enter an accounting code when they log in at the control panel.
5. Type the Connection Time-Out (1-300 seconds).
6. Click Apply to accept the changes or Undo to retain the previous settings.
Setting Up Authentication for a USB Smartcard Reader System
To use the printer with a card reader system other than Xerox Secure Access, you must order and install
the Xerox Common Access Card Enablement Kit. The kit includes hardware, software, and instructions
for connecting and configuring your card reader system.
Before you begin:
• Install a Kerberos authentication server and configure with user accounts.
• Connect your card reader to the printer.
Configure Network Authentication Settings
1. Configure network authentication. For details, see Network Authentication on page 50.
2. Configure Kerberos server settings. For details, see Configuring Authentication Server Settings for
Kerberos on page 51.
To Next Page
Loading...
Need help?
General
