Xerox WorkCentre 6015 User Manual

Maintenance
WorkCentre 6015 Color Multifunction Printer 149
User Guide
9. Close the document cover.
Cleaning the Exterior
Clean the exterior of the printer once a month.
 Wipe the paper tray, output tray, control panel, and other parts with a damp, soft cloth.
 After cleaning, wipe with a dry, soft cloth.
 For stubborn stains, apply a small amount of mild detergent to the cloth and gently wipe the
stain off.
CAUTION: Do not spray detergent directly on the printer. Liquid detergent could enter the printer
through a gap and cause problems. Never use cleaning agents other than water or mild detergent.
Cleaning the Interior
After clearing paper jams or replacing a toner cartridge, inspect the inside of the printer before closing
the printer covers.
 Remove any remaining pieces of paper or debris. For details, see Clearing Paper Jams on page 173.
 Remove any dust or stains with a dry, clean cloth.
WARNING: Never touch a labeled area on or near the heat roller in the fuser. You can get burned. If a
sheet of paper is wrapped around the heat roller, do not try to remove it immediately. Switch off the
printer immediately and wait 20 minutes for the fuser to cool. Try to remove the jam after the printer
has cooled.

Xerox WorkCentre 6015 Specifications

General

Functions	Print, Copy, Scan, Fax
Print Speed (Black)	12 ppm
Print Speed (Color)	10 ppm
Print Resolution	1200 x 2400 dpi
Copy Resolution	600 x 600 dpi
Fax Speed	33.6 kbps
Standard Paper Capacity	150 sheets
Monthly Duty Cycle	30, 000 pages
Duplex Printing	Manual
Memory	128 MB
Paper Output Capacity	100 sheets
Scanner Type	Flatbed, ADF
Fax Transmission Speed	33.6 Kbps
Paper Capacity	150 sheets
Type	All-in-One Printer
Print Technology	Laser
Scan Resolution	1200 x 1200 dpi
Connectivity	USB, Ethernet, Wi-Fi
Media Sizes Supported	A4, A5, Letter, Legal, B5, Envelopes
Operating System Compatibility	Windows, Mac, Linux
Dimensions	410 x 389 x 318 mm
Copy Speed	Black: Up to 12 ppm, Color: Up to 10 ppm