Network Configuration
WorkCentre 7755/7765/7775 Multifunction Printer
System Administrator Guide
46
NTP
Network Time Protocol (NTP) is used to synchronize the internal clocks of computers over a network
connection at system startup and every subsequent 24-hour period thereafter. This feature ensures
that the printer’s internal clock stays synchronized with the NTP server you specify. If the printer is
configured to use DHCP and an NTP server, or if the Greenwich Mean Time (GMT) offset is provided by
the DHCP server, then data entered on this page is overwritten by the corresponding parameters
retrieved from the DHCP server.
CAUTION: Enabling NTP or modifying NTP settings causes the printer to restart.
Note: If your printer is locked, you must log in as a system administrator. For details, see Accessing
CentreWare IS on page 17.
1. In CentreWare IS, click Properties > Connectivity > Protocols > NTP.
2. Under Offset of Greenwich Mean Time, select the number of hours your local time is offset from
GMT.
3. Under Network Time Protocol, select Enabled to enable the protocol.
4. Select either IPv4 or Host Name for the address type of the NTP server.
5. Type the appropriately formatted addresses and port numbers in the Primary Server and, if
needed, the Alternate Server address fields. The default port number is 123.
6. Click Apply.
To Next Page
Loading...
Need help?
General
