Network Connectivity
60 Xerox
®
WorkCentre
®
7800/7800i Series Color Multifunction Printer
System Administrator Guide
Raw TCP/IP Printing
Raw TCP/IP is used to open a TCP socket-level connection over Port 9100, and stream a print-ready file
to the printer input buffer. It then closes the connection either after sensing an End Of Job character in
the PDL or after expiration of a preset timeout value. Port 9100 does not require an LPR request from the
computer or the use of an LPD running on the printer. Raw TCP/IP printing is selected in Windows as the
Standard TCP/IP port.
Configuring Raw TCP/IP Settings
1. In Xerox
®
CentreWare
®
Internet Services, click Properties > Connectivity > Setup.
2. For Protocol, next to Raw TCP/IP Printing, click Edit.
3. On the Raw TCP/IP Printing tab, for Protocol, select Enabled.
4. For TCP Port Number, ensure that Port 1 is set to 9100.
Note: To emulate HP JetDirect EX Plus 3, set Port 2 to 9101 and Port 3 to 9102.
5. Next to Bidirectional, for each active port, select Enabled.
6. Next to Maximum Connections per Port, for each active port, type a number from 1 through 32.
7. Next to For End of Job Timeout, for each active port, type a time in seconds from 0 through 1800.
8. Next to PDL Switching, for each active port, select Enabled as needed.
Note: PDL Switching allows the printer to switch automatically between multiple supported PDLs
within a single job.
9. To save the new settings, click Apply.
10. To return all settings to the default status, click Default All.
To Next Page
Loading...
Need help?
General
