Xerox WorkCentre 7970 - Emptying the Hole Punch Waste Container

Maintenance
Emptying the Hole Punch Waste Container
A message appears on the control panel when the hole punch waste container is full.
Emptying the Hole Punch Waste Container in the Business Ready Finisher
WARNING: Do not perform this procedure while the printer is copying or printing.
1. Open the front door of the Business Ready finisher.
2. Remove the hole punch waste container from its slot near the top left of the finisher.
Notes:
− When you remove the hole punch waste container, wait 10 seconds before you reinsert it into
the printer. The hole punch counter resets after 10 seconds.
− If you remove the hole punch waste container before the device instructs you to, empty the
container before you reinsert it into the finisher.
204 Xerox
®
WorkCentre
®
7970 Multifunction Printer
User Guide