Xilinx MultiLINX Series User Manual

Hardware User Guide
1-22 Xilinx Development System
Setting Up The Cable
If you are using the Hardware Debugger Software and a PC as a host
system, manually select your cable as follows.
Output > Cable Setup
Select your cable type, then click OK.IfyouareusingtheXChecker
cable, you may also select a BAUD rate. See Table 1-4.
If you are using the JTAG Programmer software, select the cable
manually as follows.
Output > Cable Auto Connect
Select your cable type, then click OK.
Download Cable Schematic
The following figure is an internal schematic of the Parallel Cable III.
You must use the recommended lengths for parallel cables. Xilinx
cables are typically six feet (approximately two meters) in length
between the connector and active circuitry. Keep the wires between
the headers and target system as short as possible.

Xilinx MultiLINX Series Specifications

General

Brand	Xilinx
Model	MultiLINX Series
Category	Cables and connectors
Language	English