Xilinx MultiLINX Series User Manual

Hardware User Guide
2-14 Xilinx Development System
Figure 2-6 JTAG Mode (XC9000, Virtex, Spartan, XC5200,
XC4000)
Downloading/Verification of Configuration Data
This section details the connections needed for downloading/verifi-
cation of configuration data with the MultiLINX Cable in Slave Serial
Mode.
Slave Serial Mode (XC3000)
The following figure shows in detail the Slave Serial Mode connec-
tions for the XC3000 device.
D0
D1
D2
D3
D4
D5
D6
D7
RDY/BUSY
CS2
CS1
CS0 (CS)
WS
GND
CCLK
DIN
RT
TDI
TCK
TMS
RST
TRIG
RD (TDO)
PWR
VCC
RS (RDWR)
CLK2-IN
CLK2-OUT
CLK1-IN
CLK1-OUT
DONE (D / P)
PROG
INIT
4
2
3
1
NOTE: Pull-up resistors are 4.7k ohm.
Circuit Board
XILINX device
MultiLINX Connectors
see data sheet of the device (if applicable)
M0 M1 M2
INIT
TMS
PROG
TCK
TDI
TDO
(only XC4000 and SPARTAN) (only XC4000 and SPARTAN)
X8939

Xilinx MultiLINX Series Specifications

General

Brand	Xilinx
Model	MultiLINX Series
Category	Cables and connectors
Language	English