Xima L100 - Parameter Setting Methods; Restoring Defaults and Saving; Password Protection

28
o Method of Parameter Settings
- First press Enter and release it to go to the parameters page.
- If you have set the parameter  (password), you must first enter the password and then
press Enter to go to the Parameters page (If  is not zero, enter the password and press
Enter). See parameter  for more information.
- Now you can see the name of the last set group on the screen. Press NEXT to see the next
group and press PREV to see the previous group.
- Press Enter to enter the desired group. Now you can see the name of the last set parameter
in the group.
- Press NEXT to see the next parameter, and press PREV to see the previous parameter. If you
use these keys, you will see all of the parameters (Press +/- to scroll parameters).
- Press Enter to set any parameter and you will see the parameter's value blinking .
- By pressing +/- you can set the parameter value.
If you hold these keys continuously, the value of the parameter will be increasing or decreasing
with a variable speed, otherwise if you press them shortly, the parameter will be increased or
decreased for one unit.
- If you want to save the parameter changes, press Enter, and if you want to cancel the last
parameter change, press Back.
(Adjust value by pressing +/- and press Enter to save or  to not save)
- Each time you press Back, you will return one step back, and after you pressed it a few times,
you will be left from the parameters page.
Note that if you left the page without saving, the last changed parameter will be returned to its
value before the setting. Also, changing some parameters will instantaneously influence the
system's functioning, but other parameters will influence the functioning after pressing Enter
and saving them.
o Back to Initial Values and Saving
You may use the parameter  if you want to reset default values or to get a backup of the
current values or to return to the previous settings. Refer to the parameter  for more
information.
o Password
To protect the parameter values from any change made by other people, you can define a
password for the device. In this case, in order to go to the parameters page, you must first enter
the password correctly. If the password value is set to 0, it means that no password is set. You
may refer to section  parameter setting for more information.