Xima L100 - System Parameters Configuration

37
Parameter
Name
Setting range
Default value
Type

Multi Speed 3
0.00-2.50 m/s
0.30
R/W
Multi Speed 3

Multi Speed 4
0.00-2.50 m/s
0.50
R/W
Multi Speed 4

Multi Speed 5
0.00-2.50 m/s
0.70
R/W
Multi Speed 5

Multi Speed 6
0.00-2.50 m/s
0.80
R/W
Multi Speed 6

Multi Speed 7
0.00-2.50 m/s
1.00
R/W
Multi Speed 7

Rescue Time 1
0-100 s
5
R/W
Delay time before connecting the relay of enabling the control panel in
the delayed rescue mode

Rescue Time 2
1-1000 s
200
R/W
Connection time of relay of enabling the control panel in the delayed
rescue mode
o System Parameters
Parameter
Name
Setting range
Default value
Type

Password
0-9999
0
R/W
If this parameter is set to a non-zero number, you must first enter this
number as a password when you are entering the parameter setting
page .
It is better to keep the parameter 0 before the settings are finalized,
because it is easier to enter the parameters page. After finalizing the
settings, set this parameter to a desired number to prevent the
parameters being changed by other people.
Note that you must select a value not easily forgotten, and save it in a
safe place if possible .
If you forgot this parameter value, contact the company.

Restore/Back-up
0-4
0
R/W
Dummy State: Nothing happens.

Restore to Default: set this parameter to 1 and hold ENTER for 5
seconds, the drive saves the current parameter values into the
device memory and restores all the parameters to their default
value.
