Xima L100 - Page 46

45
In the second method (Jerk Mode), the inverter takes control of the process of stopping at the
top of the floors based on jerks and the decelerations.

Stop Method
0-1
1
If the standby method is based on the jerk, then  must be set to  and
the following parameters are set in the parameter list.

Deceleration
0.00-1.50 m/s
2
0.70

Jerk 3
0.00-0.50 m/s
3
0.80

Jerk 4
0.00-0.50 m/s
3
0.80
Fig. 22: Stopping the elevator with the Xima inverter and the related parameters




