Xima L100 - Page 49

48
How to fix
Cause
Problem
parameter) from the
second menu.
First, increase Jerk 1
() gradually.
If the vibration is not
removed, increase the
ACC acceleration
parameter () .
If there is not any
vibration in the start of
some floor levels, the
problem can be related to
the mechanical system.
It is required to set the Jerk1 and
Acceleration parameters.
Vibration of the
cabin when
starting the
elevator
Change the parameter
 from the Quick
Menu or main menu.
X0 settings must be changed .
Leveling magnets must be installed
carefully.
Problem with
leveling
In a few steps, reduce the
parameter  for about
10%, from the Quick
Menu or Main Menu.
In this case, the leveling speed is zero,
and we must reduce the X3 value. The
reason is that the magnets have not
carefully placed in the elevator well.
Passing the level
of the floor
Increase the parameter
 or the leveling
speed, in a few steps.
If you still have the
problem, increase the
leveling time by one to
three steps.
The first reason for this bug is a
mechanical problem. If this vibration is
accompanied by a strike at the end, we
should increase the leveling speed, and
next, we should increase the leveling
time.
Vibration when
stopping
The default leveling speed
 is too high for your
system; reduce it to 4.5 Hz
or 0.09 m/s.
Problem with matching the leveling
speed and the landing distance .
Cabins and weights not being balanced.
striking when
stopping
First, increase the low-
speed coefficient . If
the problem still exists,
increase the leveling
speed  step by step.
It is needed to set the leveling speed and
low-speed coefficient (torque boost)
more carefully
Remaining at the
leveling speed
The default value of 
is set to zero. By
increasing this parameter,
reduce the chance of Roll
Back.
It is required to set the time of enabling
the mechanical brake by the 
parameter.
Reverse rotation
when Roll Back
stopping