Xo FLEX - Infection Control and Maintenance Checklist

XO FLEX – Instructions for use Infection control and maintenance checklist
76
9 INFECTION CONTROL AND MAINTENANCE CHECKLIST
Below is a summary of infection control (section 5) and maintenance procedures (section 6):
Table 11 – Infection control and maintenance routines
What
How
Parts/consumables needed
Every morning
Finish overnight water line
disinfection procedure (step 2)
Check that unit instruments are
still in the instrument holder on
the cuspidor.
See section 5.20.1
XO Water Clean cartridges
See section 10.3.
Remove cuspidor bowl and
protection disk
See section 5.18
Fit clean suction filters
See section 5.19.2
Check that the rubber feet of the
foot control are clean to avoid
sliding
See section 6.1
Petroleum benzine
Switch the unit on
Before each patient
Fit sterile / disinfected / new:
Extra:
• unit instrument pad
• bridge protection pad
• handles
• covers for suction nozzles
• cuspidor bowl, protection disk
and gold trap
• cup holder
See sections 10.2 and 10.3.
•
Unit instrument pad
• Bridge protection pad
See section 5.6
•
Handles on instrument
bridge, light and HD Display
See section 5.7
•
Covers for suction nozzles
See section 5.19.1
• Cuspidor bowl, protection
disk, gold trap with cover
and cup holder
See section 5.18
• Unit instrument hoses and
balance suspensions if
necessary
See section 5.8
See section 10.2.
Fit sterile / disinfected unit
instruments
Syringe – see section 5.9
Micromotors – see section 5.10
XO ODONTOSON 360 – see
section 5.12
XO Peristaltic Pump – see
section 5.15
XO ODONTOCURE – see
section 5.13
Extra:
• syringe tips
• syringe covers
• micromotor covers, please see
bienair.com
• XO ODONTOSON 360
instruments, please see xo-
care.com for complete list
• XO ODONTOCURE light rods
etc.
See sections 10.2 and 10.3.
Place a new cup
After each patient
Remove contaminated:
• Unit instruments
• Unit instrument pad
• Bridge protection pad