Xo FLEX - XO Odontocure Curing Light Operation

XO FLEX – Instructions for use Operation
30
As a matter of course, the titanium tips will become worn down with time due to use. The efficiency
of an instrument will therefore be gradually reduced.
Several factors contribute to wear of instruments:
• Time used
• The type and consistency of calculus deposits in patients
• The quantity of irrigation being used
The lifetime may therefore vary considerably from instrument to instrument.
XO ODONTOSON 360 WITH ANTIMICROBIALS AND STERILE SALINE
In combination with XO Peristaltic Pump, XO ODONTOSON 360 can be used with antimicrobials or
sterile saline.
Prepare the peristaltic pump as described in section 3.16.
Insert the connector piece (XO-069) between the hose and the handpiece – as shown in Figure 27.
Figure 27 – Connector piece for external irrigation of XO ODONTOSON 360
Attach the irrigation tube to the connector piece using the appropriate outlet – see Figure 28.
Figure 28 – XO ODONTOSON 360 connected to external irrigation
3.15 XO ODONTOCURE CURING LIGHT
The intended use of XO ODONTOCURE is polymerization of light cure resin based composites
used for fillings in human teeth.
Lift the curing light forward and control it with the foot control.
See the current exposure time on the display before the foot control is activated.
Choose between three different exposure times with ▲ and ▼ and see the selected time on the
instrument bridge display.
Start the curing process with ⮕ or ⬅.