3-22
3
System diagram
Single outboard motor application
(*1) Install the waterproof cap to the open terminals.
1 Trim sensor
2 Trim sensor coupler
3 Speed sensor
4 Water pressure sensor
5 Engine ECM
6 Pigtail bus wire
7 Single hub
8 Main bus wire
9 703 remote control box
0 Fuse (10 A)
A Terminal resistor
B Tachometer unit
C Fuel meter unit
D Speedometer unit
E GPS
F Engine start switch (with engine shut-off
switch)
G 8 ft power wire
H Fuel tank (fuel level sensor)
a Bus port
b Device port
c Power port
È 703 remote control model
É 704 remote control model
Ê PORT
Ë STBD
Color code
B: Black
G: Green
L: Blue
P: Pink
P/B : Pink/Black
R: Red
W : White
Y : Yellow
Battery installation / System diagram
To Next Page
Loading...
