Yamaha F200C Service Manual

LOWR
Lower unit
6-43
69J1D11
Removing the drive shaft
1. Remove the drive shaft assembly and
pinion, and then pull out the reverse gear
and thrust bearing.
Disassembling the drive shaft
housing
1. Remove the cover, oil seals, and needle
bearing.
Disassembling the reverse gear
1. Remove the needle bearing from the
reverse gear using a chisel.
Disassembling the lower case
1. Remove the retainer and shim(s).
2. Remove the needle bearing from the
retainer.
3. Remove the needle bearing.
Drive shaft holder
1
: YB-06201
Drive shaft needle bearing remover
and installer
1
:
YB-06196
Driver handle
2
: YB-06071
È
Universal puller
1
: YB-06117
Puller bolt
2
: YB-41707
Needle bearing installer
3
:
YB-06434
Driver handle
4
: YB-06071
È

Yamaha F200C Specifications

General

Max Power Output	200 hp
Prop Shaft Horsepower	200 hp
Full Throttle RPM Range	5000-6000 rpm
Alternator Output at W.O.T.	50A
Compression Ratio	10.3:1
Exhaust	Through Propeller
Lubrication	Wet Sump
Ignition	TCI (Transistor Controlled Ignition)
Starting System	Electric
Gear Ratio	1.86:1
Gear Shift	F-N-R
C.A.R.B. Rating	3-Star
Steering	Remote
Displacement	2785 cc
Fuel Induction System	Electronic Fuel Injection (EFI)
Recommended Engine Oil	Yamalube 4M
Recommended Fuel Filter	Yamaha Fuel/Water Separating Filter (10 Micron)
Engine Type	4-Stroke, DOHC, 16-Valve In-Line 4
Bore x Stroke	96.0 x 96.2 mm
Fuel	Unleaded gasoline (87 octane minimum)
Cooling	Water-cooled, Thermostatic Control