Yamaha F200C Service Manual

69J1D11
3-6
1
2
3
4
5
6
7
8
9
Changing the engine oil using an oil
changer
1. Start the engine and warm it up.
2. Remove the engine oil dipstick and oil
filler cap
1
.
3. Insert the tube of the oil changer
2
into
the dipstick guide
3
.
4. Operate the oil changer to extract the oil.
NOTE:
Be sure to clean up any oil spills.
5. Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
6. Install the oil filler cap and dipstick, and
then start the engine and warm it up for 5
minutes.
7. Turn the engine off, and then check the
oil level and correct it if necessary.
Changing the engine oil by draining
it
1. Start the engine and warm it up.
2. Remove the engine oil dipstick and oil
filler cap
1
.
3. Remove the starboard apron
2
.
4. Place a drain pan under the drain hole,
and then remove the drain bolt
3
and let
the oil drain completely.
Recommended engine oil:
4-stroke motor oil
API: SE, SF, SG, SH, or SJ
SAE: 10W-30 or 10W-40
Oil quantity:
Without oil filter replacement:
5.8 L (6.1 US qt, 5.1 Imp qt)
S69J3120
Fuel system / Power unit

Yamaha F200C Specifications

General

Max Power Output	200 hp
Prop Shaft Horsepower	200 hp
Full Throttle RPM Range	5000-6000 rpm
Alternator Output at W.O.T.	50A
Compression Ratio	10.3:1
Exhaust	Through Propeller
Lubrication	Wet Sump
Ignition	TCI (Transistor Controlled Ignition)
Starting System	Electric
Gear Ratio	1.86:1
Gear Shift	F-N-R
C.A.R.B. Rating	3-Star
Steering	Remote
Displacement	2785 cc
Fuel Induction System	Electronic Fuel Injection (EFI)
Recommended Engine Oil	Yamalube 4M
Recommended Fuel Filter	Yamaha Fuel/Water Separating Filter (10 Micron)
Engine Type	4-Stroke, DOHC, 16-Valve In-Line 4
Bore x Stroke	96.0 x 96.2 mm
Fuel	Unleaded gasoline (87 octane minimum)
Cooling	Water-cooled, Thermostatic Control